gt2560 or 2860
#7
Tour de Franzia
Thread Starter
iTrader: (6)
Join Date: Jun 2006
Location: Republic of Dallas
Posts: 29,085
Total Cats: 375
that was my thought, but I went with the #3 intercooler, so I'm not really worried about heat. I was thinking of the bigger turbo to get some head room, and I'd like to make 230-240whp at the lowest psi possible. However, if I end up with a 4.10 or 3.90 rear end, I'd hate to punished myself if I don't keep the revs up enough on the track...since that's about the only place I drive this car now.
#9
Tour de Franzia
Thread Starter
iTrader: (6)
Join Date: Jun 2006
Location: Republic of Dallas
Posts: 29,085
Total Cats: 375
I also have not decided on engine management, but its up to Xede or whatever comes out of DIYautotune for MS. I'm leaning toward Ms right now.
#11
Tour de Franzia
Thread Starter
iTrader: (6)
Join Date: Jun 2006
Location: Republic of Dallas
Posts: 29,085
Total Cats: 375
i dont' have a ******* clue whats going to happen on the dyno...but it would be nice to advance mechanical timing a hair to move the powerband forward if I need to spool the bigger turbo sooner. I don't really feel comfortable sitting the car on the rev limiter at the race track now...and really won't with FI.
#12
Elite Member
iTrader: (9)
Join Date: Aug 2006
Location: Concord, North Carolina
Posts: 4,160
Total Cats: 6
I just ordered a 1.8 S3 from Bell. Now you guys can give me **** for leaving the kit in the garage too long. I still have to find a motor, rear end, and 01 sport brakes.
I also have not decided on engine management, but its up to Xede or whatever comes out of DIYautotune for MS. I'm leaning toward Ms right now.
I also have not decided on engine management, but its up to Xede or whatever comes out of DIYautotune for MS. I'm leaning toward Ms right now.
#17
Limits and efficiency of the compressor. Read turbo tech 3 on turbobygarrett.com and do the calculations.
I would go with the 2860r disco potato, since you'll be tracking it you don't have to worry about the spool up times and there will be no lag in higher rpms, this turbo will pull all the way to the redline, 2560 will run out of breath in higher rpms.
I would go with the 2860r disco potato, since you'll be tracking it you don't have to worry about the spool up times and there will be no lag in higher rpms, this turbo will pull all the way to the redline, 2560 will run out of breath in higher rpms.
#18
Supporting Vendor
iTrader: (33)
Join Date: Jul 2006
Location: atlanta-ish
Posts: 12,659
Total Cats: 134
I just ordered a 1.8 S3 from Bell. Now you guys can give me **** for leaving the kit in the garage too long. I still have to find a motor, rear end, and 01 sport brakes.
I also have not decided on engine management, but its up to Xede or whatever comes out of DIYautotune for MS. I'm leaning toward Ms right now.
I also have not decided on engine management, but its up to Xede or whatever comes out of DIYautotune for MS. I'm leaning toward Ms right now.
Congrats dude.
<checking temperature in Hell>
#19
Boost Czar
iTrader: (62)
Join Date: May 2005
Location: Chantilly, VA
Posts: 79,493
Total Cats: 4,080