Who I still running a 6" rear with 10+psi?
I'm probably going to upgrade before mine breaks to help pay for the 7" swap, but just wondering.
|
Still running mine with about 10-11 psi. I autocross the car but am careful especially with 1-2 shifts. I've only been running my setup for a couple of months though.
I've known people running 15psi FM II setups on the 6" rears for years and have no troubles. Mechanical empathy goes a long way I suppose. |
I'm not sure why you would think that 10PSI will break it. I run 15 PSI in mine with no problems. Of course, I've totally trashed rear ends with NA cars - it is all in how you treat them.
|
I'm still running the 6" rear. Next week the LSD 7" goes in. No problems yet on the 6", just leary.
|
i am. same thing, just very cautious.
|
i am running mine at 12-13 so far so good.
|
i ran my car at around 8-10psi. It never broke, but then i never did anystanding starts, or etc. with it.
|
Yeah I'm not hard on it really, never clutch drop it, shift into 2nd kinda hard sometimes at autox, but what I mainly want it for is to swap in an RX7 LSD. My VLSD is gettin me down. Ruins all my fun.
|
i have an ATS LSD, its a 6" rear but can i still swap to 7" or would i need a new lsd.
|
no you need to swap the whole pumpkin halfshafts and drive shaft to have it all work.
|
what he said. The weak link in the 6" is the ring and pinion, and you'll need all that magnamx-5 listed to go to 7"
|
still on the look out i think i might have finally found a 1.8 parts car to give me all the parts fingers crossed.
|
All times are GMT -4. The time now is 01:38 PM. |
© 2024 MH Sub I, LLC dba Internet Brands