AEM 1710 on 90 Miata with 1.8 swap
02-03-2008, 06:13 PM
#1
Senior Member
Thread Starter
iTrader: (10)
Join Date: Nov 2006
Location: Raleigh,NC
Posts: 912
Total Cats: 0
AEM 1710 on 90 Miata with 1.8 swap
Anybody got a map I can load on AEM 1710 on a 90 Miata with 1.8 swap? Right now I just loaded the 90-93 1.6 map on it, but it take a while to crank up the engine. Also can I use the GM IAT sensor on diyautotune to remove the air flow meter?
Last edited by supra441979; 02-03-2008 at 06:39 PM.
Reply
0
0
02-04-2008, 09:01 AM
#2
Elite Member
iTrader: (9)
Join Date: Jun 2006
Location: Chesterfield, NJ
Posts: 6,892
Total Cats: 399
I have some AEM maps but I'm not running any stock sensors so you are better off startign with the AEM defaults and following all the AEM instructions exactly. It will work well if you do so. Even with your 1.8.
Yes, you can use the GM IAT sensor from diyautotune (I am running the same, but I buy my stuff from the local chevy dealership) to remove your stock flapper air flow meter. However you have to redo your lead for the fuel pump as it runs thru the air flow meter on the 1.6's. There are a few ways of doing this, I think I read one way on braineak's FAQ. Also, all the settings for the GM IAT sensor are in the wizard settings for the IAT sensor so it does not require much effort software-wise.
Yes, you can use the GM IAT sensor from diyautotune (I am running the same, but I buy my stuff from the local chevy dealership) to remove your stock flapper air flow meter. However you have to redo your lead for the fuel pump as it runs thru the air flow meter on the 1.6's. There are a few ways of doing this, I think I read one way on braineak's FAQ. Also, all the settings for the GM IAT sensor are in the wizard settings for the IAT sensor so it does not require much effort software-wise.
Reply
0
0
Thread
Thread Starter
Forum
Replies
Last Post
