your planned mods for next year
as above.
mine are: - DO WI - FMIC to replace saab crappy 900 one - 3 piece rear wing - maybe a paint job (colour change) - 305 cc injectors - more dyno time :bigtu: now its your turn...... |
Get turboed! (I've given up for this year, with family visits starting Friday).
That and finish repairing/painting front bumper cover and TSIs. And probably some FCM stuff, too. |
Finish my DIY turbo kit, get it installed. Finish the rebuild of my 1.8 and tranny that are sittn in my garage. Retire the miata from daily driver service and enter it into fun time only service.
|
7" diff - Torsen or maybe clutch LSD
MegaSquirt Khumo MXs or Falken RT-625s Racing Seats 2.5-3.0" Exhaust Heavier Clutch 250rwhp Most likely in that order. |
finally finish my IC pipes and get it on there
up the boost and shoot for 200-220rwhp new wheels/tires new midpipe/exhaust |
new air/air ic
finally hook up the dead weight that is my WI probably convert fuel to AN lines perhaps a bottom end. or not. or boom. 6UL wheels rebuild some of my exhaust goodnuf |
Starting January,
install new exhaust install bigger fuel rail and AN fittings for fuel lines new clutch & flywheel 7''diff and ATS LSD & cryrogenic treat the ring & pinion and stronger halfshafts redo nitrous system to a direct port fogger harddog rollbar install momo seats more chrome under the hood |
In no particular order
|
|
Install
Tony's DP 1.8 brakes Fm butterfly brace NACA duct headlight lid DIY Dual feed rail EGT gauge Find/Purchase/Steal Link or Hydra and 440-550 injectors. |
Get my damn car running!
|
Oh my where to start. For the parts I currently have sitting in my garage:
Install 1.8 rear with rx7 lsd, 1.8 axles and driveshaft Install TEC3 and fab up intake pipe and cold air box after afm removal Install rollbar Install chro-moly lightweight flywheel Make spare headlight lid into NACA duct For the stuff I have yet to purchase: New clutch New top New paint Recover seats |
Momo Start seats on floor
Custom 6pt Rollbar DO WI waiting to be installed Install SR20 T25 sitting on my floor EGT and Oil Temp Gauges Hopefully redo entire turbo setup with T3 mani/dp and over the rad IC. |
finish the wiring and fab on my TEC3
tune it NA on a set of 444cc injectors give car to my friend for the manifold, dp, exhaust and IC piping fabrication fab some brackets for my fd calipers |
fab front air-scoop
finally hook up my LC-1 lower drivers seat fab divorced downpipe cover car until spring. |
New I/C piping over the radiator
New Big Intercooler instead of the starion New exhaust post-cat If I win the lottery: Redo downpipes/divorced wastegates Ladder bracing Polyurethane bushings GT25R's in place of the GT15s Buy M2CupCar's FE |
MS&S, hopefully if I keep working out of town (2x income) I can get the 99 salvage car gutted, stuffed in my 91, and get buy the fm system.
If I can just get MS in the car I'll be satisfied. |
Originally Posted by Ben
(Post 66548)
In no particular order[LIST][*]oem 15" wheels, would love to find an affordable set of the bbs that came on the 95M, but would settle for some M2s
http://www.miata.net/cgi-bin/isc/cla...evaction=today |
Originally Posted by jayc72
(Post 66677)
Ask and ye shall recieve.
|
Jesus you are such a bitch. Affordable is relative :)
Those are gay wheels anyway. |
:fawk: Affordable is relative. $1k for Miata rims is insane. :jerkit:
I've got 2 extra sets of rims for my otm, each was over $1k, but on a nearly $60k car. |
lol.
Get turbo'd...start raping the annoying/loud GT Mustakes that other dumbass college kids like to brag about. |
Originally Posted by m2cupcar
(Post 66559)
and also possibly try to get MS water injection going. |
Kegorator and maybe an alignment rack...
Oh, for the car :) Suspension upgrade--still deciding, paint the front bumper (still sanding) maybe throw in the act clutch that's been on the shelf... Then there's the MX3 and P5--- a lot longer lists :) saving for college, retirement, finishing up another degree--all while maintaining 2 cases of beer a week :) |
Originally Posted by getsidewaysd1
(Post 66584)
Get my damn car running!
My electrical system is fried. Got the dash out now tracking down burnt wires and gremlins. Plans: -DO WI -IC spray (water) -stickier tires for drag racing -buy a better camcorder and hook it up to my new camera mounts on rollbar (record some much requested BOV sounds for you guys) -redo control panel (car has very no stock control stuff like turn signal stalk left - mounted everything in place of radio surround) -DIY catch can install |
-MOMO Start on the passenger side
-pads, lines, and rotors -re-mount harnesses -RB tubular sway -FM butterfly -KONI RACE/GC combo -clutch&flywheel -begin DIY turbo build |
|
paint it honda champioship white,and roll the fenders.
some decent tires 3'' from the downpipe back. probally kyb agx's and tien springs. different steering wheel. corbeu 3 point harness. |
I'm trying to be optimistic and think I'll get it turboed in the next 12 months, but in all reality I'll probably just continue to accrue parts when I can. In the next 12 months I hope to get a house (and thus a garage) and pick up a leftover 07 MS6 so the Miata is not a DD and I can have it on jackstands for a while during the install and inevitable fucking up. Hopefully the Miata will be running 250-300whp in 16-18 mos. Delayed gratification FTL. Smart financial decisions FTW.
|
suspension mods, repaint
|
Fresh paint, tune with more boost, maybe new wheels, then sell the car.
|
Comp. Motor Mounts
Act clutch 440cc injectors GM Solenoid EBC Custom exhaust work (car is way to quiet now with Turbo) |
RUSMAN- What are you replacing it with???
As for me. Selling and replacing with a 350Z. Anyone interested let me know. |
I don't know yet, maybe bmw, I really have no idea, I'd love to have an evo but can't really afford one. Might get some luxury vehicle:rly:
If someone wants to buy my car, give me an offer. |
My list in no particular order:
-Figure out why my autotune and WBO2 don't agree on how rich/lean the car is running -BOV -raise boost from 4psi to 8 or 10psi -torsen -Simpson Design short rear bumper -start putting together a WI setup -corner weight and realign the car -remind Steelrat that his car is slow :gay: I'm sure that there are more things that will come up too... |
07 will be the year I get off my tail and stop researching and start building... probably mega squirt then forced induction...
|
Originally Posted by RusMan
(Post 66822)
Fresh paint, tune with more boost, maybe new wheels, then sell the car.
|
All times are GMT -4. The time now is 09:52 AM. |
© 2024 MH Sub I, LLC dba Internet Brands