Payment sent.

I'm in, I'll email you...

^^ Whoah! Cool Ryan! :)

Yep, we're in it together now!

I'm good for one... Check sent! And Travis... Thanks for answering all those pesky questions!

Payment sent.

Payment sent.

hope you guys dont mind I wait for payday tomorrow. :D :D :D

Paid up!

Paid.

I'm paid up.

I've got 11 of you guys down invoice paid in full, including one cashiers check. I had 16 on the list, and I know atleast a couple were going to pay with check. So we're right on schedule!

Travis

pait

Can't wait!

Check's in the mail.

Paid last night, let me know you got it.

16 buyers?! Damn, this is a mt.n ECU Revolution! In terms of total cost this has to be a record group buy.

i was once in on a complete Tec3 ECU + install hardware group buy. I think that was over 30k total.

Damn, not going to be able to make this one. Hopefully there will be another over the summer or fall that I can get in on. Travis, you should become a sponsor on miata.net also, you could probably sell another 10-15 on a group buy there. I'm looking forward to reading about the successes and issues you guys will have with this ECU, it's at the top of my list for my next ECU purchase.

It is alot of cash moving around its 11.5k I think? I'm hoping I don't have to do anything special to wire this much to Adaptronic. I really didn't think it would take off this well!

I'm going to sponsor M.net and a couple others once I get my other products out.

I've got those fully assembled oil pump housings that have been beed blasted clean to a bling bling shine, and machined to perfection with 10% larger gears for more flow.

I've got the ignition kit, that really is coming soon. We keep having problems with his flasher to put the programming into the new digital dwell control.

I've got the aluminum cam gears out as soon as I get final qoutes from manufacturers, which will probably be later this week and I've got the carbon center versions w/titanium hardware coming up as soon as we get his flasher working. We made this computer to control the heating of the composite material. We can control rate, and peak w/ a nice digital interface, but we can't program the chips yet to implement the software!!! (That company is on my list if the new flasher doesn't show up today!)

Then the intake manifolds I plan on having mostly done by the 30th. We are setting a side a whole week for testing, and getting it right. So when all this stuff comes together I'll go to other sites.