mach5

So as I have ac lights wipers and radio on car started reving higher up and down around 2k now jumped up to 3500 and stuck. Tun off turn on stuck at 3500 no matter what I turn on or off

mach5

K pulled temp sensor still runs whitout a beat pullied mani pressure ocilates but stays on.

RotorNutFD3S

iTrader: (33)

You'll need your laptop to diagnose but check your TPS readings. With the car off, make sure your TPS reading is '0' at closed and '100' at full open, cycle the pedal a few times to make sure. Then turn the car on, if the TPS window registers '1' or higher at idle (assuming the car is idling at 3500RPM), there's your problem.

If it's doing this, adjust the Throttle Closed numerical value up in the Hydra settings (until the TPS closed reading is '0') and the car should operate correctly.

From the Hydra manual:

mach5

So how do I get into these tps reading window Jeremy was telling me about this from flyin miata

RotorNutFD3S

iTrader: (33)

You need a computer with the Hydra software loaded onto it that you will hook up to the Hydra. If you have your manual, it will walk you through all this.

mach5

so I see it in the mode screen under the first map screen.

RotorNutFD3S

iTrader: (33)

If by mode screen you mean the main screen you see after you upload your current map from the ECU, then yes, that is where you see the TPS window (which is at the bottom left).

This is an old screenshot of the main screen, but you get the idea:

mach5

reading the manual now from flyin miata

RotorNutFD3S

iTrader: (33)

Good. I think pages 9 and 10 cover adjusting the Throttle Position Sensor and calibration.

Faeflora

iTrader: (2)

spek engleshe plz

mach5

So I was told that this number can go up or down and I can adjust a number 2-3 points over what it is what and where would I do this in the throttle screen?