Harbor Freight Win-or-Fail Thread
So i just found an integrated LED brightness dial/adjuster in the USB connector. Glad I didn't waste $0.14 on the instructions upgrade.
These are all unadjusted jpegs with LEDs on full bright.
view from 11"

view from 7"

view from 4"

view from 2"
These are all unadjusted jpegs with LEDs on full bright.view from 11"

view from 7"

view from 4"

view from 2"
That's the other reason I bought it. If the camera head is truly 7mm it'll work for anything around .30 caliber. Not sure you are going to ram that down the barrel of a .270 without some effort. I'd be super convenient if it was bout, say, 5mm, but I'll take what I can get. For $8 how can you go wrong? (Unless it just does not work of course)
The US general 26" 4 drawer tool cart is good for the money:

This jigsaw is useless garbage:
http://www.harborfreight.com/5-amp-h...saw-69582.html
The blades twist about 10 degrees and eject themselves every few minutes.

This jigsaw is useless garbage:
http://www.harborfreight.com/5-amp-h...saw-69582.html
The blades twist about 10 degrees and eject themselves every few minutes.
re eBay endoscope:
Camera housing has outer measurements of 7mm x 35mm (rigid barrel)
Given the discussion, I should note that the cord/able does not really hold a position if you bend it- it's not semi-rigid. You'll need to attach to something as spine for any control during penetration.
Camera housing has outer measurements of 7mm x 35mm (rigid barrel)
Given the discussion, I should note that the cord/able does not really hold a position if you bend it- it's not semi-rigid. You'll need to attach to something as spine for any control during penetration.







