next MS project
#1
next MS project
I've decided that I am going to run an MS3 on my 69 charger. The Goal will be to run a crank trigger, remove the distributor, run individual coil packs, sequential injection, dual WB02, etc.
It's going to be a little while before I start this because I would have to get rid of my miata to do it ASAP. I'm not ready to give up the miata.
I just thought that props to this site and everyone on here was due again. Without the knowledge I have picked up here, this would have been out of my relm. Now it seems quite easy.
What are your opinions on stroking a 440 to 500+ cubic inches?
It's going to be a little while before I start this because I would have to get rid of my miata to do it ASAP. I'm not ready to give up the miata.
I just thought that props to this site and everyone on here was due again. Without the knowledge I have picked up here, this would have been out of my relm. Now it seems quite easy.
What are your opinions on stroking a 440 to 500+ cubic inches?
Thread
Thread Starter
Forum
Replies
Last Post