kenzo42

iTrader: (6)

So I'm 300 miles away from home and I hear this weird sound from the 94 Integra (140k miles) whenever I push in the clutch to the floor, like a rubbing sound. Can't isolate the sound.

Rubbing/metallic sound when:

-clutch pushed in (only 1st and 2nd gear makes sounds and only at low speed) and also makes sounds at a dead stop w/ clutch pushed in
-hard to shift into gears (all gears)
-car seems to stutter a bit @ <5 mph
-runs fine when actually in gear

Throw out bearing?

Thanks.

patsmx5

iTrader: (16)

If it's the TOB

It will make sound when clutch pedal is pressed to the floor.
Make sound when you put pressure on the clutch pedal but don't actually push the clutch in. (just pushing the TOB agains the PP)
Sound disappears when clutch is disengaged. (TOB is away from the PP and no longer doing anything)

kenzo42

iTrader: (6)

Would the TOB also making shifting notchy and hard to get into gear?

patsmx5

iTrader: (16)

I dunno. If it's not pushing the the PP all the way then yes it will make it hard to shift into gear. If you're hearing the sound like i described it's the TOB. Gonna have to pully the trans. to change it. Use a Timekon (sp?) or other known good brand. Ebay TOB's are known to fail. Also make sure the thing has grease in it. (rare but it happens!)

Fireindc

iTrader: (13)

Not sure if this helps.. but on my 94 Integra with the same miles, the CMC went out. Perhaps its leaking? Check the floorboard of the car to see if there's any fluid.

944obscene

Its the flux capacitor. Biff got into your car again.

kenzo42

iTrader: (6)

Were you exhibiting similar symptoms? I know my CMC is bad as well.

bryantaylor

iTrader: (5)

i am a acura parts counterperson, let me know if you need any parts for it. i usually have the TOB in stock, and the CMC is only a day out. i can get you prices if you want some tomorow.

Arkmage

iTrader: (3)

when my pilot bearing siezed I has a similar set of symptoms. just a thought.

georgefury1

+1 to bryantaylor, Honda factory parts are AWESOME!! Honda parts are a little pricey, but you get what you pay for. Are you still riding the original clutch? You might think about going ahead and changing it while the tranny is already off.

Fireindc

iTrader: (13)

My CMC failure did not show similar symptoms. +1 on replacing the clutch when/if you pull the tranny.

hustler

iTrader: (6)

whatever it is doesn't eraly matter because you have to take the clutch out. I had a clutch puke the springs out and tear **** up (exedy stock replacement).

bryantaylor

iTrader: (5)

i didn't know you had to pull a clutch to do a master, learn something new everyday

patsmx5

iTrader: (16)

If it's making bad metallic grinding noises, it's not the master or slave. If it were either of those it just wouldn't go in gear.

greenday3437

iTrader: (2)

+1, im thinking TOB or part of the actual clutch assembly