DIY MS2e Gone Sequential Injection but Won't Start
06-15-2016, 09:47 PM
#1
Junior Member
Thread Starter
iTrader: (1)
Join Date: Aug 2014
Location: Wisconsin
Posts: 78
Total Cats: 12
DIY MS2e Gone Sequential Injection but Won't Start
DIY MS2e was running great on batch fire, so I had to go and mess with it by putting the JB Perf Quad Ignition & Injection board in.
I followed all the instructions for the Quad Board.
Using testmode, outputs were working through the DIY BOB with the Jim Stim.
I put it on the car, and it doesn't even try to catch.
Everything I'm looking at looks OK to me in the logs I just have no clue what to look for now.
Stock ECU is getting me around just fine now while I grapple with this. Swapping MS2 in and out is only a couple minutes job.
Attached is the tune, datalog, and composite log. Please let me know if I can provide anything else that may help you help me.
~Chris
I followed all the instructions for the Quad Board.
Using testmode, outputs were working through the DIY BOB with the Jim Stim.
I put it on the car, and it doesn't even try to catch.
Everything I'm looking at looks OK to me in the logs I just have no clue what to look for now.
Stock ECU is getting me around just fine now while I grapple with this. Swapping MS2 in and out is only a couple minutes job.
Attached is the tune, datalog, and composite log. Please let me know if I can provide anything else that may help you help me.
~Chris
Reply
0
0
Thread
Thread Starter
Forum
Replies
Last Post
