2001-2005 DIY megasquirt build documentation?
I have a 2003 Miata, and I was hoping to buy a megasquirt from Braineak, but he seems to be taking a hiatus of an unspecified duration. I have started looking into building my own, but it seems like there's not very much documentation for 2001-2005 megasquirts.
The DIYautotune folks only go up through 2000; will that work for 2003 also? I'm not terribly confident in my electrical engineering skills, but I can follow directions if they are detailed enough. so I guess my questions are: Is there a pre-assembled PNP MS specifically for 2001-2005? If not, is there any difference between building an MS for 2000 and 2001-2005? If yes, is there a detailed build document somewhere? I would like to be able to run the MS in parallel with the stock ECU, just like Brain had it set up, so I don't have to worry about VVT (though I think someone mentioned to me recently that MS3 can do VVT? I haven't seen anything else about that though). I hope this isn't a redundant question; I've done quite a bit of searching, and it seems like MS documentation is scarce for post 2000 models. If this has been covered elsewhere, please direct me to the appropriate thread. Thanks! Nikolai |
Of course there is a Megasquirt for the 2001-2005; PM me for more. :)
|
Here you go, full instructions.
If you don't like the connector inside the case, no problem, just make a wiring loom. 99-05 MS3 | Frank's Westfield MX5 99-05 MS3 | |
That's perfect, thanks very much! I looked over the instructions for a while yesterday, and it's not as intimidating when you see all the steps laid out like that.
|
All times are GMT -4. The time now is 06:41 AM. |
© 2024 MH Sub I, LLC dba Internet Brands