90-93 MS3PNP and knock sensor
Just got finished wiring my knock sensor in via the expansion plug for my MS3PNP. Knock sensor signal is on Pin B and Sensor ground is Pin A. However I am not sure as how to configure the sensor and the settings in TunerStudio. The sensor is a 2 pin GM knock sensor from a Silverado/Sierra truck. I checked GM Service information for the correct pin out for the connection. I used shielded wire from the sensor to the expansion plug.
http://www.megasquirtpnp.com/docs/ms....php?isModel=1 http://www.megasquirtpnp.com/docs/im...optionConn.png What settings do I use for the sensor such as input pin? The link I specified is the information I am going off of. It doesnt specify Analog 3 or Digital 3 etc, just knock sensor. So I am stuck as to what to select in TunerStudio for the correct input pin and how to activate the input pin. Any help is appreciated. |
Got it figured out. Called DIY and the sensor input under knock settings should be set to Internal. Hope this helps anyone else with the same concern.
|
You might have an easier time using a stock nb knock sensor since it fits into a miata engine easily and the settings for those sensors are pretty easily found for megasquirt.
|
All times are GMT -4. The time now is 02:22 PM. |
© 2024 MH Sub I, LLC dba Internet Brands