92Miata

iTrader: (3)

Im building my MS2 and I have it all done, But im trying to look for a place to run an EBC and Vics Switch.

I have launch control wired to js11.
Joe P`s ign mods through js10.
Fan control through d15 and q7.

I know how to make the circuits for Vics and EBC i just dont know what ports i can use.

Any help ?

92Miata

iTrader: (3)

Looks like i can move launch control to JS4 and use JS11 for bost control. that solves that issue.

but cant find one for vics.

WestfieldMX5

Braineack

iTrader: (62)

pics of what you did. I bet you modded it for a MSI board.

92Miata

iTrader: (3)

right now i have nothing but the stuff in the asembly section of the MSII part from the wiki you gave me.

92Miata

iTrader: (3)

accorrding to his diagram i can use,

js2 for vics
js7 for launch
js11 for boost

there is already a diagram for building the boost circuit on the how to, but what do i follow for the other two ? if they have changed from ms 1.

92Miata

iTrader: (3)

Can anyone confirm how to properly set up the Launch and vics circuits on an ms2 ?

Braineack

iTrader: (62)

for launch you can just hook the clutch switch directly to an input, for VICs you need to use a relay like the fan control and put it on a spare output.

92Miata

iTrader: (3)

Ok vics is easy then, and just so I understand correctly, I can take a jumper from JS7 through a spare port on the db37 to ground and that will trigger vics when set up in Tunerstudios ?

Braineack

iTrader: (62)

js7, through a 1K resistor to a p2n2222 transitor, back out to a spare port on the db37 then to the vics solenoid, yes.

92Miata

iTrader: (3)

im sorry i miss typed that i was asking that question for launch control.