95 Standalone harness - Help needed
Ok, I'm inches away from being done with the construction of the whole MS gizmo. I have 3 wires left coming out of the bundle and need some help as to where they meet up on the factory end.
I am running standalone on a 95 1.8. Will be running a LC-1 WB and GM IAT sensor. I did the idle and fans mod per Braineack's instructions. After a few failed attempts to locate an answer for my questions, I figured I would just throw them out and hope for the best at this point. The three wires coming off the DB37 are F-IDLE (Pin 30), TPS VREF (Pin 26), and IAC1-A (Pin 27). They need homes on the factory end! I believe the F-IDLE just meets up with the BLU/ORG wire running to the IAC valve, but want to get verification before I hook it up. Any help with this is appreciated. TIA. |
On the '95 ECU harness, FIDLE will go to the blue / orange wire at 2W, TPS Vref to the green / white wire at 2K, and IAC1A (assuming that's configured internally as your second trigger input) to CMP, which is the yellow / blue wire at 2G. (the primary tach lead, pin 24, will go to CKP, the white wire at 2E.)
Also, the '95 uses an isolated ground for all of the analog sensors. This is the black / blue wire at 2D. Make sure that wire is connected to one of the MS's ground pins. |
Thanks, Joe! That's exactly what I was looking for.
|
Originally Posted by Joe Perez
(Post 348574)
On the '95 ECU harness, FIDLE will go to the blue / orange wire at 2W, TPS Vref to the green / white wire at 2K, and IAC1A (assuming that's configured internally as your second trigger input) to CMP, which is the yellow / blue wire at 2G. (the primary tach lead, pin 24, will go to CKP, the white wire at 2E.)
Also, the '95 uses an isolated ground for all of the analog sensors. This is the black / blue wire at 2D. Make sure that wire is connected to one of the MS's ground pins. I also double checked that there is a ground to 2D. |
OK, a quick check shows that pin 27 where this comes off comes from IAC1B, and there isn't anything in IAC1B yet. Now I have to double check my IAC and fans mods to make sure this is correct.
|
Originally Posted by Cpt_Slow
(Post 349347)
OK, a quick check shows that pin 27 where this comes off comes from IAC1B, and there isn't anything in IAC1B yet. Now I have to double check my IAC and fans mods to make sure this is correct.
FWIW, all the places you had questions about should be in my writeup... |
All times are GMT -4. The time now is 12:58 AM. |
© 2024 MH Sub I, LLC dba Internet Brands