johndoe

iTrader: (5)

Going to try to load the Hi-Res firmware today for my MSPnP. Following the instructions from here http://ozmx5.com/viewtopic.php?f=4&t=13 it says to copy your existing project folder. My existing project folder was using the MAF but the copy of Hi-Res I'm going to be running is for the GM IAT sensor. Should I still copy my original project folder, or should I copy the project folder for no MAF (that I haven't used)? Does it make a difference?

KPLAFIN

iTrader: (1)

From my limited experience with MS... I would make one major change at a time. So either get it running with the IAT THEN switch to the HiRes or switch to HiRes then get her running with the IAT once that's all done.

Mach929

iTrader: (3)

yeah i'd switch to running the gm iat, make sure it works, then switch to hi-res

kotomile

iTrader: (24)

+1

johndoe

iTrader: (5)

er...to late for that. Probably would have been a good idea though. Still doesn't answer my question.

timk

I'm the author of those instructions and I agree with what everyone has said about one change at a time. To answer your question; if you want to change to HR and lose your MAF at the same time you should copy the "no MAF" project folder.

johndoe

iTrader: (5)

I would have liked to change one thing at a time but time constraints didn't really allow that. If **** doesn't work right I know it's my own fault. Thanks for the answer though.