Where to take boost readings from?
#1
Where to take boost readings from?
As the title says, Im at the stage where Im plumbing up my actuator and boost controller.
I remember reading about it before on here, but I cant seem to find it now!
Anyway, my question is, can I take the boost reading off the intake manifold, where my MAP sensor ready to the ecu comes from? As in just put a splitter in the line there, on to the solenoid and one to the MAP sensor? IS this even a boosted area?
Doing this would save me the hassle of putting another fitting into my intercooler pipe work.
And if this is possible, would I be able to split it again when the pipe goes into my ECU/MAP sensor, and then run my boost gauge off that too?
Any help would be appreciated, I tried to find where I read that but no luck!
I remember reading about it before on here, but I cant seem to find it now!
Anyway, my question is, can I take the boost reading off the intake manifold, where my MAP sensor ready to the ecu comes from? As in just put a splitter in the line there, on to the solenoid and one to the MAP sensor? IS this even a boosted area?
Doing this would save me the hassle of putting another fitting into my intercooler pipe work.
And if this is possible, would I be able to split it again when the pipe goes into my ECU/MAP sensor, and then run my boost gauge off that too?
Any help would be appreciated, I tried to find where I read that but no luck!
Thread
Thread Starter
Forum
Replies
Last Post
stoves
Suspension, Brakes, Drivetrain
5
04-21-2016 03:00 PM