AC always on
 

DIYPNP 94/95
diyautotune base map with AC turned on. (OUTPUT=ALED) (INPUT=PE1) (POLARITY=LOW)

1Q->INPUT 1 IN
INPUT 1 OUT->PE1

No matter what, the AC remains turned on. Tuner studios is showing that AC is constantly being requested on. This is a used one that i redid and everything seems to be ok. wired and setup exactly as other 94/95 that i have done with no issues. works fine on stock ecu.

I am wondering if there could be an issue with input 1 on the board causing it to get a constant ground signal to PE1. I dont have it in hand at the moment so i cannot test it for sure.

When i got this used one in it was missing U5 and the AC switch input 1Q was going straight to PE1 and not through the input 1.

Thanks to any of those who might have some input on this. ECU has firmware 3.4.2