AFM Wiring
I was looking for a way to wire in my boost control solenoid and realized that the 2K pin is unused and goes to the AFM connector, which happens to sit right where my boost control solenoid will be. Any reason I can't wire up that pin for boost control?
http://www.miata.net/garage/ECU%20Pi...90-93%20MT.pdf http://www.rivercityroad.com/garage/jpg3/afm2.jpg |
I use 2O to send the fuel pump signal out and 2P for the AIT sensor.
2K is the 5vref, so that's available. this is wrong: http://www.rivercityroad.com/garage/jpg3/afm2.jpg looking at it that way it's: Chassis ground | Fuel Pump Relay | Sensor Ground | 5v | Sensor Ground | Airflow Rate | Air Temp |
Thanks. I thought it would work, just double checking.
|
All times are GMT -4. The time now is 02:46 PM. |
© 2024 MH Sub I, LLC dba Internet Brands