Easytherm Settings
#1
Junior Member
Thread Starter
iTrader: (1)
Join Date: Nov 2011
Location: Peoria IL
Posts: 51
Total Cats: 0
Easytherm Settings
What settings do I use for the IAT/CLT on Easytherm if I have the stock MAF on a 96? I think it is flashed for the GM AIT right now, I got it running but it is stumbling in the midrange RPMs. Thanks!
#2
Elite Member
iTrader: (2)
Join Date: May 2007
Location: Cromwell, Connecticut
Posts: 2,604
Total Cats: 16
https://www.miataturbo.net/megasquirt-18/96-coolant-sensor-curve-55633/
Bias resistor value will depend on if u are parallel or standalone.
Bias resistor value will depend on if u are parallel or standalone.
#3
Stuck with Easytherm
Hi MS fellow users,
I have a 94 1.8 Miata I am stuck with Easytherm to configure the CLT/IAT Settings.
GM IAT from diyautotune
Standalone Bias Resistor both 2490ohm
IAT: 48F - 7000ohm CLT: -4F - 16150ohm
87F - 1930ohm 104F - 1150ohm
146F - 560ohm 176F - 330ohm
Is it correct?
My problem, I fill everthing in Easytherm out, then it says Output done and after that when I wanna dowload it to Megasquirt, I got a Runtime error:
"Runtime error 13: Type mismatch"
And it doesnt generate the 3 inc files....
Any help would be appreciated.....
I have a 94 1.8 Miata I am stuck with Easytherm to configure the CLT/IAT Settings.
GM IAT from diyautotune
Standalone Bias Resistor both 2490ohm
IAT: 48F - 7000ohm CLT: -4F - 16150ohm
87F - 1930ohm 104F - 1150ohm
146F - 560ohm 176F - 330ohm
Is it correct?
My problem, I fill everthing in Easytherm out, then it says Output done and after that when I wanna dowload it to Megasquirt, I got a Runtime error:
"Runtime error 13: Type mismatch"
And it doesnt generate the 3 inc files....
Any help would be appreciated.....
Thread
Thread Starter
Forum
Replies
Last Post
Zaphod
MEGAsquirt
47
10-26-2018 11:00 PM
StratoBlue1109
Miata parts for sale/trade
21
09-30-2018 01:09 PM
stoves
Suspension, Brakes, Drivetrain
5
04-21-2016 03:00 PM