Skylerxb

Hey everyone, I have been a lurker for a while now but I have a question that is bringing me out of the woods. I installed mspnp2 over the weekend, set the base map, verified timing, installed a wideband (Innovate MTX-L), and deleted the MAF. Anyway, when the car is between 14:1 and 15:1 AFR the wideband gauge and the gauge in TunerStudio are pretty much spot on with one another, but below 14 or above 15 the gauge in TunerStudio stops reading. Is this just a simple setting change in TunerStudio to allow the full range of motion on the gauge?

Matt Cramer

Please make sure you have set the correct calibration curve under Tools -> Calibrate AFR Table.

Skylerxb

I will double check it, but I set it to what logworks was telling me it was at.

Skylerxb

I found the problem. I connected the innovate to MS via the brown wire, rather than the correct yellow wire.