Almost ready to fire mine up for the first time
 

I need the local Radio Shack to open up so I can get a 470 ohm resistor for the TPS (I have a 1.6)

I have loaded up Aussie Driver's settings and base maps, will this be good enough to get me started?

Also, as long as I keep the stock MAF in, I dont have to mess with the Fuel Pump switching. Correct?

Anything else I should watch out for? I am gonna take baby steps and only try Fuel first.

You will probably find a few errors with my .msq if you are running the temps in farenheight, as my .msq is set up for celcius. If you change the temp units in MSnSE to celcius, you should be able to get your car going without too many problems.

Just remember though that my fuel map has only been tuned with a narrow band O2 sensor and the seat of my pants. Be prepared to tune it a lot more.