altering spark table to match fuel table?
I"ve been using the orginal DIY map table load points and rpm points but I'm somewhat at odds with it and want to try moving it so under 100 is in mutiples of 10 and above is in mutiples of 25 so it will be like
10,20,30,-,100,125,150,etc I figure if I do that I will also have to alter my spark table mapping, does that sound about right? and if anyone has doen it on a 1.6 or 1.8 have a spark table map that I can look at to see what they changed it to ms2extra 3.1 code |
If you mean that you intend to rescale the fuel table and believe that you must then rescale the spark table such that the two use the same scale, this is not necessary. The spark and fuel tables are independent, and need not share the same scaling on either axis.
|
Multiples of 10 under 100kpa will piss you off. I set a row for overrun, a row for idle, and then typically space by 15kpa from there. Any tighter and you waste a lot of time tuning cells that the ECU is more than capable of extrapolating.
|
Originally Posted by Savington
(Post 742380)
Multiples of 10 under 100kpa will piss you off. I set a row for overrun, a row for idle, and then typically space by 15kpa from there. Any tighter and you waste a lot of time tuning cells that the ECU is more than capable of extrapolating.
|
All times are GMT -4. The time now is 09:23 AM. |
© 2024 MH Sub I, LLC dba Internet Brands