Am I missing something totally obvious?!?!
Hey Guys,
I have a MS V3 board that is wired up for standalone on a 1.6 NA. When I run the download.bat to upload the firmware with my easytherm settings and connect MS up to my computer running MSe and the stimulator I get all the signals to work fine. My problem is when I load the pnp msq file I get no tach reading. What is going on here? Is this something with the stim and it will work when I install it? I have the MS modded for IAC and followed the miata pullups. I am so confused can someone please help. Thanks -Adam |
Once you mod the MS for the miata mods the STIM will no longer provide a tach signal unless you mod the stim's R4 to 200ohm 1watt resistor, might have to disconnect the D1 pullup as well (or D2 w/e it is.)
Don't worry, just get it finished and test it in the car. |
Thanks a ton, that is something I wanted to hear. I was worried to put it in the car because I worried sensors were messed up. I am going to install it later next week once I finish finals. Thanks for the help.
|
All times are GMT -4. The time now is 06:58 AM. |
© 2024 MH Sub I, LLC dba Internet Brands