Hesitation and erratic AFR under part throttle
04-08-2016, 06:32 PM
#1
Newb
Thread Starter
Join Date: Oct 2014
Posts: 1
Total Cats: 0
Hesitation and erratic AFR under part throttle
Hi all from the UK
Recently turbo'd my MX5 using a MSPNP Gen1
All was well during tuning on the dyno but on normal running the car hesitates and the AFR goes all over the place on part throttle.
On full throttle the AFR stays perfect and same goes for off throttle.
It has a BMW E36 VTPS and the modification of adding the two wires and removing R6 and 7 I have just found has already been done.
When I notified the Tuner he suggested change plugs so I changed them for NGK ....7. (The correct ones for a turbo MX5)
Any ideas as to wether his is a tuning issue or a physical issues would be greatly appreciated!
Other info:
Tuner has a good reputation for tuning with mega squirts in the UK and helped my wire in the VTPS as the voltage appeared to go the wrong way when calibrating the TPS.
New Bosch 550cc injectors.
9 PSI boost on a TD04
Cheers
Chris
Recently turbo'd my MX5 using a MSPNP Gen1
All was well during tuning on the dyno but on normal running the car hesitates and the AFR goes all over the place on part throttle.
On full throttle the AFR stays perfect and same goes for off throttle.
It has a BMW E36 VTPS and the modification of adding the two wires and removing R6 and 7 I have just found has already been done.
When I notified the Tuner he suggested change plugs so I changed them for NGK ....7. (The correct ones for a turbo MX5)
Any ideas as to wether his is a tuning issue or a physical issues would be greatly appreciated!
Other info:
Tuner has a good reputation for tuning with mega squirts in the UK and helped my wire in the VTPS as the voltage appeared to go the wrong way when calibrating the TPS.
New Bosch 550cc injectors.
9 PSI boost on a TD04
Cheers
Chris
Reply
0
0
04-09-2016, 06:12 PM
#3
Boost Czar
iTrader: (62)
Join Date: May 2005
Location: Chantilly, VA
Posts: 79,493
Total Cats: 4,080
did you calibrate the TPS and tune your TPSdot enrichments correctly?
and I dont understand removing R6 and R7.
R6 is part of the barttery voltage circuit and R7 is a pull-up resistor for the CLT sensor...
MS is designed for vTPS, there is no internal modifcations that need to be done in order to accept it.
and I dont understand removing R6 and R7.
R6 is part of the barttery voltage circuit and R7 is a pull-up resistor for the CLT sensor...
MS is designed for vTPS, there is no internal modifcations that need to be done in order to accept it.
Reply
0
0
Thread
Thread Starter
Forum
Replies
Last Post
dwiddowmaker
Miata parts for sale/trade
10
04-20-2016 08:31 PM
