Anyone have an .msq file I can use to get me going on my turbo?
I have the Megasquirt (standalone with idle/fan/EBC mods-no solenoid for EBC yet though-can I just use a manual boost controller for now?) up and running NA on the car with AFM, so it works and runs although a little rough...so next I thought I would add the IAT and get it running on that...then the 550cc hi-z RX7 turbo injectors...once I have it running on all of that I figure I can add the manifold/turbo/AEM Ungo wideband and at this point it might be a good idea to go ahead and use someone's proven .msq to get me close on this setup and then tune from there...am I going about this the best way? Thanks!
|
If your car is running on the pnp map then i would just tune from that. Get your fuel to an acceptable tune and then get on the dyno and finish tuning fuel then do the spark map.
|
Wideband should be in your immediate plans.
|
Install your wideband now.
Install your IAT now. Use the MSPNP .msq to get you going, then scale it for injector changes (search). Your plan seems fine otherwise. |
All times are GMT -4. The time now is 06:42 PM. |
© 2024 MH Sub I, LLC dba Internet Brands