Miata Turbo Forum - Boost cars, acquire cats.

Miata Turbo Forum - Boost cars, acquire cats. (https://www.miataturbo.net/)
-   MEGAsquirt (https://www.miataturbo.net/megasquirt-18/)
-   -   Anyone hear from Rev lately? (https://www.miataturbo.net/megasquirt-18/anyone-hear-rev-lately-80139/)

d_bomb 07-24-2014 08:36 PM

Anyone hear from Rev lately?
 
Hey guys,
I bought a MS3 board from him a few months ago. I've been doing alot of reading and trying to get it into my car without asking stupid questions. Well, I came across a thread where a guy posted instructions that Rev sent him with his, but some of it was cut off. Mine never came with instructions which is why I've been so lost, not knowing where to start. I PM'd him and haven't gotten a response for almost a week now. Before he would respond within a day when I bought it from him. Has anyone heard from him? Maybe my PM got lost in what I assume would be a flood of messages he gets daily. Or does anyone have a full copy of his install instructions that would work for a MS3 into an '04?

Thanks everyone,
-Devin

18psi 07-24-2014 08:39 PM

what specific problem are you experiencing?

EO2K 07-24-2014 08:45 PM

He will probably have custom firmware you need to get running, depending on your specific model of MS. I know what's what we had to do with my MS3-Basic.

PM incoming.

d_bomb 07-24-2014 09:43 PM

My specific problem is finding out where to begin lol. I know I never posted here before, but I'm far from new to the automotive scene. Last time I had megasquirt was the very first version of MS2 years ago. Never got it installed because I got hit by a drunk driver and totalled my car. Well, since then I've dealt with more fabrication and carburated engines. Now I'm getting back into the 'tuner' scene and want to learn to deal with EFI. I have everything to turbo my car, the hardware/fabrication side is no issue for me. However, I'm trying to take a safe, easy route into the tuning side, which is why I bought a pre-built ECU that will hopefully be mostly plug-n-play. I have the wideband O2 and IAT sensor also. But I never got any instructions, just the test sheet, so it's left me kinda lost. Everything I read about MS is way beyond where I stand right now lol. I learn from doing, hands on, so reading all this info isn't doing me much good until I can put it into play.

Anyhow, that's kind of a mini-introduction, explanation of my issue, and hopefully a message to show I'm not an idiot, even though this may seem like the easiest thing for some of you lol.

And I got the PM, thank you.

EO2K 07-25-2014 01:01 AM

Go make a real intro thread and we love you long time, sounds like you've got a lot going on.

But yeah, like I said, Rev'll sort you out. Good luck and have fun!

Dlaitini 07-25-2014 02:23 AM

yeah I sent Rev an email and a PM in the past couple weeks and have not heard anything

Reverant 07-25-2014 03:35 AM

Been moving for the last couple of weeks. I still don't have a landline and DSL, and I barely have 3G internet access on my cell phone (to tether). Even getting my emails reminds me the 90s. Click receive, go make a coffee, get back, still at 40%, go do some chores, maybe it will be at 80%+ by the time I'm done.

Argh.

Engi-ninja 07-25-2014 03:51 PM

I was kind of wondering about this too; I sent my megasquirt and VVTuner to you at

Mpoumpoulinas 90

12462 Chaidari

Greece

Apparently it's being processed in the Greece mail facility right now; will you be able to get it?

Reverant 07-25-2014 04:28 PM

Its in customs right now. I've given a forwarding address to the post office, so it should be redirected to the new address.

Engi-ninja 07-25-2014 04:34 PM

Awesome, sounds good!

d_bomb 07-25-2014 10:44 PM

Tomorrow I'm installing everything and hopefully getting a decent tune by the end of the day. The car is bone stock so it shouldnt be too bad. Going to replace my stock O2 with the wideband instead of putting in a new bung, this should work, right? Couldn't find anything about anyone else doing it on the stock exhaust other than all the threads should be the same. Seems like if it's a good enough location for stock, why not for my application?

Twodoor 07-26-2014 03:07 AM

Glad to here you are OK Reverent!

I sent an email requesting instructions on installing the A/F ratio digital box to make my MS3 get the same signal as my wideband display. Should I re-send the e-mail or are you digging through old emails and I would just add to the problem?

Keith

Reverant 07-26-2014 03:42 AM

Send me a new request, I've configured my email program to only fetch the last 100 emails to help me with this issue until I have a DSL line again.

Engi-ninja 08-04-2014 08:34 AM

Hey Dimitris,

The last update I received on the location of my package was that it was in customs on the 24th of July...so it's been in customs for almost 2 weeks. Should I be concerned about that?

Reverant 08-04-2014 02:37 PM

PM me the tracking number.

Engi-ninja 10-14-2014 08:08 AM

Hey Rev, any update on the MS? If not, I'm going to talk to USPS about what to do to get it sent back I guess.

Reverant 10-14-2014 01:05 PM

Will send another request to the customs tomorrow to process the package.

Engi-ninja 10-14-2014 01:07 PM

Ok great, thanks!


All times are GMT -4. The time now is 05:54 AM.


© 2024 MH Sub I, LLC dba Internet Brands