Bench testing EBC
 

I just added EBC to my MS but id like to make sure that the circuit works. I dug around in megatune but I just cant figure out how to make it engage at 110kpa so I can see if the middle leg and the gnded leg are opening and closing.

What menu should I be in and what values should I change?

I dont think you'll be able to with the stimulator, since the mods kill the RPM signal, and you need at least 100rpm to activate it.

what i'd would do is hook the solenoid up, tune the DC map to be 100% throughout the entire map....the solenoid should close, when you get over 100rpm