boost table /MAC Vavle 04 MSM
08-31-2014, 10:13 AM
#1
Junior Member
Thread Starter
iTrader: (1)
Join Date: Mar 2013
Location: Traverse City, Michigan
Posts: 138
Total Cats: 4
boost table /MAC Vavle 04 MSM
details
04 MSM
Mac Valve
rev built MS2 +
hey guys so I've searched and read and searched but i guess I'm not finding exactly what I'm needing .. trying to figure out some base boost map settings for running this mac valve
were shooting for 12-13lbs since its stk turbo. I've got my boost protection set to 200 kpi (14lbs) and on the dyno our stk internal gate was hitting 10lbs. (creep)
i know i need to change the boost controller setting to closed loop (correct?). I'm lost all the settings on the boost table are set at 100 (from rev and I'm told the setting are all pre set up.. ) is up i.e 101 raise or lower boost? sorry for the newb questions just trying to learn this software..... any and all help even bashing... hahha thanks again!
04 MSM
Mac Valve
rev built MS2 +
hey guys so I've searched and read and searched but i guess I'm not finding exactly what I'm needing .. trying to figure out some base boost map settings for running this mac valve
were shooting for 12-13lbs since its stk turbo. I've got my boost protection set to 200 kpi (14lbs) and on the dyno our stk internal gate was hitting 10lbs. (creep)
i know i need to change the boost controller setting to closed loop (correct?). I'm lost all the settings on the boost table are set at 100 (from rev and I'm told the setting are all pre set up.. ) is up i.e 101 raise or lower boost? sorry for the newb questions just trying to learn this software..... any and all help even bashing... hahha thanks again!
Reply
0
0
Thread
Thread Starter
Forum
Replies
Last Post
