Brain MS3 no Fuel pump
Hey,
MS3 from Brain on a 05 miata, the fuel pump does not start, where should I look ? I checked continuity on harness and it is ok, I check the FP circuit and it looks fine (continuity checked too), I noticed that D8 and R16 are missing. Thanks Elior |
Is this on a MSM?
|
Check if R40 is installed.
|
1 Attachment(s)
Not an MSM - it is a 2004 NB sport,
As I understand it R16 from the fuel pump circuit is needed and missing - I installed it - will test tomorrow. In the pic you can see the missing R16 and that R40 is there. |
Yes, that's required. Sigh... :cry:
sorry about that one. |
It works fine now.
The reading from the AEM WB was ok just a little of on TS/MS, since the first time I tried to calibrate it, it does not read anything anymore ... the AEM output wire does read normal (changing) numbers... Please advise. Thanks Elior. |
hmmm. Nothing about the calibration should make it stop inputting. Is it possible the connection got severed when you fixed the unit? Or changed the wbo2 to a different input in software by mistake? What happens if you try re-calibrating for AEM UEGO again?
|
I tried a few pre-cal WB that are there, with no success, it was running good just a bit off, I tried to change the cal nums and the moment I pressed "write" it stooped responding and is showing full rich.
I will check the WB input settings again. I think I got it, I disabled EGO control and I disabled the "EGO Sensor type", that would disable the WB input reading ? |
yeah, even with EGO disabled, you need to make sure the sensor type is correct.
|
All times are GMT -4. The time now is 08:50 AM. |
© 2024 MH Sub I, LLC dba Internet Brands