Braineack MS3X EBC
Hi All,
I have a Braineack MS3X and i would like to install a MAC EBC. I am having a little issue with the wiring and would like your help. According to Braineack's manual i should connect my EBC to 4AF and 4X wires on my MAF connector as shows below: https://cimg2.ibsrv.net/gimg/www.mia...711c7846f7.jpg and according to the following diagram 4AF (White/Red) is a 12V and 4X (Pink) is a signal: https://cimg5.ibsrv.net/gimg/www.mia...bf3acad68f.jpg So i connected one wire to the white/red and the second one to the pink: https://cimg2.ibsrv.net/gimg/www.mia...7c007e36bf.jpg I used the test-mode in tunerstudio to test the wiring: https://cimg6.ibsrv.net/gimg/www.mia...5b9c0688ef.jpg I tried different frequencies and nothing, no clicking from the solenoid. I then connected the one wire to the white/red and the second to the black and heard a click, which i guess means that the solenoid itself is OK. Below are my boost control settings: https://cimg6.ibsrv.net/gimg/www.mia...78dd66aa64.jpg Any idea what could it be? The other thing that i an trying to figure out are the vacuum lines,with no electricity i took a straw and blew air into port 2, the air went out via port 3 which seems to be right, so i connected the turbo outlet to port 2 and port 3 to the wastegate, this way if the solenoid fails the turbo will work with its wastegate, and when there is a signal it will navigate the air to port 1 (atmosphere) https://cimg6.ibsrv.net/gimg/www.mia...917d289ed4.jpg did i get it right? Thanks, Rom |
can you confirm our harness has a green/red wire going to 4P and not loose like the pink o2 wire was?
|
I will take a look, but while i will have it out from the car, could you please advise from what pin it goes to the the 4X, so i would install one if it is missing?
Thanks! |
I meant 4X when I said 4P. should be a green.red wire labeled EBC or BOOST that goes from the ecu connector to the MS.
|
Pin 6 "Boost" according to the below pic is connected only to DB connector side:
https://cimg5.ibsrv.net/gimg/www.mia...5f3074abb1.png https://cimg6.ibsrv.net/gimg/www.mia...d85e8f7326.jpg https://cimg9.ibsrv.net/gimg/www.mia...c5eb19e17d.jpg Should i just weld it to 4X pin? Thanks. |
you must have an earlier one where i didnt start putting boost through the MAF connector as a standard. either run a wire out or try to add it to the connector at 4x. Running a wire out might end up being easier...
|
I've addded it to th 4X, now its working.
Did i get the vacuum lines right? Thanks! |
All times are GMT -4. The time now is 10:47 AM. |
© 2024 MH Sub I, LLC dba Internet Brands