CRC mismatch
06-26-2017, 10:46 AM
#1
Newb
Thread Starter
Join Date: Dec 2016
Posts: 8
Total Cats: -5
CRC mismatch
Hi, I am running MS PNP2 with a 1993 miata.
This is what happened when I went to install the GM IAT sensor off of DIY autotune, I have it threaded in good, wires go into pins 1 and 6 in the MAF plug, The problem is when i go into Tuner Studio and select the "Calibrate Thermistor Tables" tab then change it to air intake temp and select the GM sensor then hit "write to controller".
Once i hit "write to controller" it pauses then this message pops up (see attached picture).
Has something to do with CRC Mismatch, Any advice on how to fix this?
Also I can not calibrate the AFR table as well, same message pops up.
This is what happened when I went to install the GM IAT sensor off of DIY autotune, I have it threaded in good, wires go into pins 1 and 6 in the MAF plug, The problem is when i go into Tuner Studio and select the "Calibrate Thermistor Tables" tab then change it to air intake temp and select the GM sensor then hit "write to controller".
Once i hit "write to controller" it pauses then this message pops up (see attached picture).
Has something to do with CRC Mismatch, Any advice on how to fix this?
Also I can not calibrate the AFR table as well, same message pops up.
Reply
0
0
