Can someone verify Correct spark output?
I have to constantly be messing with something electronic, this damn megasquirt project got me stuck on it. That said I decided to pull the case back off my megasquirt and verify that I wired everything up correctly for the two inputs from CAS and two spark outputs. From the beginning I believe I used DIYautotunes mods, but I did the mod a long time ago before v3.0 was released if I remember correctly.
Anyway I'm planning on using the stock 1995 Miata coil packs. So what I did was removed the transistor from Q9 and Q11, from the ouput side of R25 I soldered on a wire and ran it to X13 for coil number one. Output side of R28 to X12 for coil number two. Thats all I remember it telling me I needed to do, but now I look at their site and the redirect to a Neon site tells me I need to use some transistors or something? Ack! I'm confused, just want to make sure this is all right before I Blow something up. Now I'm really getting paranoid. The input section is perfect, I've checked that like 11tybillion times now. MSnS-E 029q2 v2.2 MS-I |
Back in the day when I first did a megasquirt on my 90 the only way I could get it to run was what you described. So, you must have copied my instructions, that mod should work for the 95 coils as well.
|
spark output must be inverted if running without the resistors, else you'll burn out the ignitors.
It also proved to be a more unstable signal, imho, i never had a smooth idle, and always had misses. Reverting to DIY's method, using the transitors and taking the signal off the LEDs, my idle became much smoother and misfires are a thing of the past. Spark output signal must be reverted to non-inverted |
So you would defiantly recommend grabbing the transistors/resistors and using them to trigger the ignitors?
|
yes. you can buy the transistors and 1k resistors at radioshack for about $4.
install the transistors, then jump, IIRC (dont hold me to it), r23 (closest to transitor) to the - labeled side of the LED, and r27 the same. run the outputs from the same resistor/LED spot to your x13 and x12. like this: https://www.miataturbo.net/~web1_braineack/MS/v2b.jpg remember, non-inverted spark output. |
Do the DIYautotune mods and use their settings. They work, they're stable, and everyone else is running them with 100% success.
|
All times are GMT -4. The time now is 08:24 AM. |
© 2024 MH Sub I, LLC dba Internet Brands