Can't get A/C to work.
I've built a diypnp for my 2000 miata. I've set up A/C exactly per diyautotune's instructions. Every time I look at the transistor for input 1 its blown. I've replaced it twice. Any idea where i should go from here?
|
how "exactly" do you have it wired?
|
1P to the input and both 1S and 1I to the output and this is on the input 1 circuit.
|
and you removed r14 or whatever?
I like to have the MS control the a/c activation and let the MS idle up, so I always take input 1 OUT to PE1. then I run ALD or WLD to 1S and 1I. |
yes r14 is removed.
|
Still having issues with this. I'm not sure what is going on. Still blowing the transistor. As stated above i've got it wired exactly per diypnp instructions, with r14 removed.
|
if youre blowing transistors then you have something wired incorrectly.
it's a very simple circuit: when you turn the a/c on it sends a ground to the input circuit, that in turn sends a ground back out to 1S and 1L--activating the a/c fan and a/c compressor relays. I'd reach out to DIYAUTOTUNE for better advice. |
I'll post this here but bear in mind it's for a 2001!
http://y8spec.com/megasquirt/images/...x_ac-setup.png |
he's not even bring it into software.
it's going into the relay and right back out. no CPU is involved. |
If I have something wired wrong I can't think of what it could be. It's only three wires. A/C worked great before the DIYPNP install.
|
it's more than three wires... it's the circuit the three wires are connected to as well.
so a transistor, 4 resistors, and an IC. did you install U3 backwards? |
I wasn't aware u3 was part of the circuit so i said to myself "that is a good question". But, yes, u3 is installed correctly.
|
move it to input two and see what happens?
|
Is input 2 identical? Would I have to remove a resistor for this circuit as well?
|
yeah the 2.2K one. cant remember off hand which it is.
|
So I started the car with the a/c inputs and outputs now going through input 2 circuit. I cut out the 2.2k resistor. Turned the A/C on and nothing happened. Didn't hear the click of the a/c relay and the transistor for input 2 is just fine. I'll resolder the connections to make sure they are good, but to me they look good.
|
Well I got it working. I used input 2. Not sure why input 1 didn't work. Also wired it through pe1 and wled. Thanks for the help everyone.
|
All times are GMT -4. The time now is 10:12 AM. |
© 2024 MH Sub I, LLC dba Internet Brands