Miata Turbo Forum - Boost cars, acquire cats.

Miata Turbo Forum - Boost cars, acquire cats. (https://www.miataturbo.net/)
-   MEGAsquirt (https://www.miataturbo.net/megasquirt-18/)
-   -   Car behaving like it's hitting boost cut, but limit already raised? (https://www.miataturbo.net/megasquirt-18/car-behaving-like-its-hitting-boost-cut-but-limit-already-raised-57287/)

GrahamC 04-24-2011 06:54 PM

Car behaving like it's hitting boost cut, but limit already raised?
 
2 Attachment(s)
Hi all,

I finally got round to fitting all my turbo gear over the past two days, and managed to take it out for a spin.

Around 8psi (actuator pressure) I hit a brick wall and the car seems to shut down all power and the car bucks erratically. If I ease off the accelerator it goes back to normal.

What I've described seems to be typical of a boost limit cut right? Only I've already raised this in megatune to a stupid high figure which I'm unlikely to hit (300kpa).

Can anyone enlighten me on what's going on? Are my spark plugs at fault? I didn't think that spark blowout would behave like this.

I've attached my MSQ and log of the problem. Ignore the shitty AFR's at the moment! I only got up and running tonight, so they're a little rich right now.

http://farm6.static.flickr.com/5302/...70c9f8c3_b.jpg

Braineack 04-24-2011 07:05 PM

looks like you have some grounding issues. those are resets and your CLT temps are spiking down like crazy.

GrahamC 04-24-2011 07:20 PM

Sounds plausible, but why would this only happen under WOT and ~8psi? I can replicate that fault every time under the same situation.

GrahamC 04-26-2011 11:12 AM

I've ordered new spark plugs today, but while I wait for them to arrive, how would I go about checking the grounds?

So far I've noticed there is an earth strap from the back of the engine block to the chassis on the UK driver side (US passenger side). I'm also aware of a grounding point underneath the throttle body.

What exactly do I need to do? It looks like I can replace the rear strap with a new thick gauge wire and new connections, but what should I do with the one under the throttle body?

Where else should I check for faulty ground connections?

Braineack 04-26-2011 11:16 AM

gap the new plugs to .030" and see what happens. a lot time ago (cira 2007), I rmeember having this issue when I was having spark blowout...the logs would show hard resets everytime I hit around 7psi or so. Swapped plugs and wires and the the issue was resolved.

GrahamC 04-26-2011 11:40 AM

Will do mate. Fingers crossed this solves the problem.

samnavy 04-26-2011 11:50 AM

Definitelylooks electrical, but good reminder to grab a new fuel filter if you're still on the original.

GrahamC 04-26-2011 01:43 PM

Problem mother fucking FIXED :D

Pulled the spark plugs tonight to check the gap and they were about 0.45

Re-gapped them to 0.25 and the problem has gone.:noob:

Braineack 04-26-2011 02:08 PM

great!

shlammed 04-26-2011 03:58 PM

This happened once when i forgot to plug my IAT back in after doing some work to the piping.

glad to hear you fixed it!

mx-p5 07-15-2011 02:25 PM

Just picked mine up and it's acting like the OP described

Gonna try pull the plugs and check em

mx-p5 07-16-2011 12:16 PM

Recommended plugs and wires?

mx-p5 07-26-2011 08:50 AM

Replaced the plugs and wires

gapped at .044 and boost cutout is gone here as well

I tried gapped at .028 and was getting detonation on partial throttle


All times are GMT -4. The time now is 12:13 AM.


© 2024 MH Sub I, LLC dba Internet Brands