jonljacobi

If I've installed everything and calibrated correctly, what should I see on the AFR gauge in the Tuner Studio panel at idle? It should pretty much be steady at around whatever AFR is in the table, correct?

I seem to be way rich and the needle sort of stutters.

Jon

Clos561

iTrader: (3)

you wont see the afr targets in the table untill you adjust the fuel table so that you hit that target.

jonljacobi

I don't quite understand that.

I have the AF gauge added to the virtual instrument cluster and am reading off of that. I'd expect it to match roughly what is in the AFR target table. I can look at both the forced target table and the VEAnalyze Live AFR table to see the target.

I don't think the LC1 is giving the correct readings as using VEAL was making it run worse and completely different from what I was getting with the stock 02 sensor. The table was altered pretty drastically.

I'm going to try calibrating again, as I might not have let the sensor warm up long enough.

fastivab6tg25mr

my LC-1 sometimes decides to output weird numbers that make no sense for conditions or sweeps from 12:1 to 16:1 at idle with o2 corrections on (target table is 14.0:1) and set down to 500rpm... try cycling the key a few times...it sometimes fixes it for me

jonljacobi

I'll give it a shot. Thnx

jonljacobi

I didn't know you couldn't calibrate with a PC attached, or that you had to off/on the car to get the LC1 out of programming mode. Why this isn't in the manual, I don't know. Working great now!