Changing from baseline tables - how many to import
 

To get my ms3 to run sequential on 60-2 wheel I needed to start from a baseline load. There were some incompatibilities from the donor msq that caused sync loss. Since I'm starting from the basemaps, all the tables are boost-less and low rpm (for a miata anyways).

Which tables do I need to import? afr and ignition?
Do I need to import the VE too?

Most peeps seem to run the 260 kPa sensor. I have a 300 kPa sensor that I've wired in. (Had it on my TEC3) I'm using the internal sensor as a barometric sensor. Is there a simple way to scale up the tables? First pass, just extend the values up to 300 kPa? I'm a long way from getting anywhere near there, just getting ready.

Um...you'll need to import every table you plan on tuning, or do it manually.

You can easily scale adjust the table but chaning the XY values and interpolating. On my car I have more "resolution" for the higher KPA rows on my spark and fuel tables, I let the AFR/EGO correction tables take care of the lower kpa stuff, so I get more precision up top, where it counts.

I wrote a simple tool to do exactly that.
https://www.miataturbo.net/showpost....3&postcount=28