The laptops still plugged in so give me 2 secs and I will do it now.

No lines at all!

I clicked diagnostic and clicked start then cracnked with my foot flat to the floor for 10 secs and nothing. I clicked stop and still nothing. The only lines I can see are the cross hairs when I move the mouse.

I think my sensor readings look ok? Do you mean the gauges on the screen. The only one that seems to read is fuel and it reads approx 108 (Percent I think. I will have a better look when you explain which sensors you need the readings from)

I meant like coolant temp and air temp, do you see RPMs in TS when cranking?

http://i56.tinypic.com/352pwg7.jpg
These are some of the figures I got. If you need the whole log let me know how to get it on here or sent to you. I will go check the gauages now for the RPM's

I have no coolant and air temp gauge visible on my gauges.

I have Engine Speed, EAE Fuel Correction 1, Pulse Width 1, Pulse Width 2, Ignition Advance, Fuel Load, Ignition Timing 1, Ignition Timing 2. The only Gauge that moves is the fuel load which sits atabout 105% and drops to about 95% whilst cranking. Ign Timing 1 and 2 both sit equal at about 48 degrees.

right click and change them

Manifold air temp is 8 degrees

Coolant temp 3 degrees C which is about right I would say.

They dont move (They may flickers lightly) when crancking but they are registering as the above readings.

I did have to rewrite the IAT as I had left it on Celcius instead of F which you had the figures for. But That was corrected before the log above an before the last of these posts tonight.