COP trigger problems
Thread Starter
Newb
Joined: Jul 2009
Posts: 42
Total Cats: 1
From: Hong Kong
COP trigger problems
I receltly installed COP, unfortunately, I have the 12V and Ground, I check the wires and only the new wire to COP were damaged, have a new set of wire hook up and start up without any problems, except losing the rpm. But the car got more power and felt respond more faster.
But on the second day run, I lost 1&4 spark, swap back to original ecu, it have spark on 1thur4, I suspect there is something bad in my ms9093.
spark video:
ms log:
I have change the O2 senser to a new one, since the old one mess up also. Do I get any more problems then I thought after u see my log?
But on the second day run, I lost 1&4 spark, swap back to original ecu, it have spark on 1thur4, I suspect there is something bad in my ms9093.
spark video:
ms log:
I have change the O2 senser to a new one, since the old one mess up also. Do I get any more problems then I thought after u see my log?
Reply
0
0
Thread
Thread Starter
Forum
Replies
Last Post
Zaphod
MEGAsquirt
47
Oct 26, 2018 11:00 PM
