wiring in launch control to my home built MS1v3.0
#1
Senior Member
Thread Starter
Join Date: Jan 2011
Location: sacramento ,ca
Posts: 563
Total Cats: 160
wiring in launch control to my home built MS1v3.0
been searching for a launch control write up that is simple enough for me to read all morning but since im kinda slow i have not been able to fully understand what im doing. i found this page so i think im on the right track:
MSnS-Extra Hardware Manual
so according to this i should be able to run a jumper wire from JS11 to SPR4 and then run pin 6 of the DB37 to my clutch switch to make launch control work.
i just want some confirmation before i start soldering stuff. thanks for your help
MSnS-Extra Hardware Manual
so according to this i should be able to run a jumper wire from JS11 to SPR4 and then run pin 6 of the DB37 to my clutch switch to make launch control work.
i just want some confirmation before i start soldering stuff. thanks for your help
#3
Senior Member
Thread Starter
Join Date: Jan 2011
Location: sacramento ,ca
Posts: 563
Total Cats: 160
is that really necessary for a wire that only sees a ground signal?
and does the vertical 1N4001 diode need to be attached to the ground side of the switch or could it be to any chassis ground?
i was thinking :
EDIT: REDREW PICTURE
and does the vertical 1N4001 diode need to be attached to the ground side of the switch or could it be to any chassis ground?
i was thinking :
EDIT: REDREW PICTURE
Last edited by fastivab6tg25mr; 07-04-2012 at 03:44 PM.
Thread
Thread Starter
Forum
Replies
Last Post
Zaphod
MEGAsquirt
47
10-26-2018 11:00 PM