DIY MSPNP 94-95mm build help
 

So i bought a DIY kit MS2 and have soldered all the parts i want, but the instructions on DIYautotune are very vague.
Im now stuck at the part where i have to wire the connector board to the main board, and i have no clue how to read the jumper table on the DIY site. Any help or redirection to a full build tutorial that is more recent would be greatly appreciated. Ive searched everywhere but could only locate the old and outdated 3.0 board build by braineack. Mine is a 1.5b board

vague?

https://www.diyautotune.com/support/...5-mazda-miata/

this tells you EXACTLY how to populate the jumpers for the connector board.

examples: AIT to 4P, CLT to 4Q, TPS to 4M, etc.


I will concede the table use to be formatted better and it's hard to distinguish the different sections from each other.

https://cimg2.ibsrv.net/gimg/www.mia...6f8c166e9b.png

So the left column is for matching the jumpers got it. What are the other collumns for? Im a total newbie and tried to read up alot but electronics is just way over my head in terms of transistors, pull ups, etc.

do the edge pin connectors, pull-ups, and I/Os.

the trigger settings are software (and they provide a base map)

and the rest are unpopulated and unused.