Miatacrazy716

iTrader: (2)

I just completed building a diypnp setup and have been trying for the last 5hrs on how to load the firmware. I followed the instructions and I get the diypnp unit to except the current version of the appropriate firmware in the ms2loader it says it goes 100%.

I then try it in the tuner studio lite version and it identifies the diypnp unit but it shows a box saying this error. I have tried reloading the firmware half dozen times and still the same results. Anyone that can help me I would appreciate it, I was hoping on trying to start my car tomorrow but it looks grim.

Thanks, Bill

ManicGTI

I won't claim to know exact cause of your issue but thought i'd chuch the DIYAutotune guide link up in case you're working to something else. I did mine fine following this:
DIYPNP Firmware Loading Walkthrough - DIYAutoTune.com

Did you have the Boot Jumper installed?

Dave

Miatacrazy716

iTrader: (2)

That's the guide I followed. The link they give for the firmware is the link I clicked and loaded my firmware from. I also have the boot jumper in place. I am frustrated. The usb serial adapter I bought along with the diypnp would not install on my laptop. I had to install it on my wife's laptop and now this damn firmware shows me it's loaded 100% in the ms2loader.

As soon as I get it in the tuner studio and start a new project. It reads it it knows its there but tells me no firmware!! I dunno, thanks Dave for trying.

Braineack

iTrader: (62)

if the boot jumper is still in place then you didn't load firmware or follow the pretty damn clear instructions when flashing.

Miatacrazy716

iTrader: (2)

No the boot was off during the flash process

RSager11

I'm have the same thing come up word for word I spent a long time yesterday trying to figure this out on my own but no luck. Please help!

Braineack

iTrader: (62)

loading firmware couldn't be easier.

where are you failing? because if you see "verification sucessful" after watching the firmware load for about 2 minutes, then you shouldn't be seeing "no firmware loaded" once you connect to TS.