DIYPNP has intermittent RPM, no start
 

I just finished assembling my DIYPNP, and loaded on the basemap supplied by DIY. I changed a few things to suit my setup and went to start the car.
I am definitely getting fuel, and I've taken a spark plug out and confirmed that I can get spark.
Attached is my tune and my datalog.

Got the car running. I think I may have ran the battery too low and flooded the engine.
I let the car sit for a little while with a battery charger on with the spark plugs out. Then confirmed I had spark by taking out a spark plug. Then cleaned off the crank sensor.
Then put everything back together, and it started right up.