Do any of you guys let MLV tune your <100kpa cells?
2 Attachment(s)
This is the map i ended with tonight:
Attachment 200881 For shit and giggles i let MLV run its analyzer thing for cells greater than 100kpa. I generally just let it tune 100kpa and below. Targets were set to 11.4 for everything above 100kpa and MLV spit this guy out: Attachment 200882 I think there was something like 10 total cells changed, including cruising cells too. I was thinking i might plop this map in tomorrow and see what it looks like, since the changes were very small. I am yet to get TSs autotune thing working so that's why i am still playing with Megatune and MLV. |
Before autotune, I just let MLV do its thing. :shrug:
|
Yeah, I've always let MLV do everything except idle.
|
Originally Posted by Joe Perez
(Post 515112)
Yeah, I've always let MLV do everything except idle.
Seriously? Wow i thought everyone tuned it manually holding boost in each cell and tuning it in on either a dyno or a backroad.. Guess ill give this a shot tomorrow and see how it works out. Thanks! |
Every day. I even let it modify idle as I'm a bit rich there, but I do manually override those if I think it's required.
|
Just fucking hand tune, jesus christ!!!
|
Always. Then again, I rarely go over 102 kPa anyway...
|
I've never touched a single cell by hand, except for the 6 idle cells.
|
You really should look into getting TS with VEA live working. I even let it tune my idle cells now and its almost 100% perfect.
|
Originally Posted by thesnowboarder
(Post 515177)
Wow i thought everyone tuned it manually holding boost in each cell and tuning it in on either a dyno or a backroad.. Guess ill give this a shot tomorrow and see how it works out.
|
What do you guys have your settings at, specifically, the WB delay.
|
I use:
Delay: 1ms Cell Change: normal to start, hard - very hard once the tune is better. Typical settings: RPM: 1200 - 7200 MAP: 20 - 255 CLT: 140 CUSTOM FILTER: [TPS] < 5 Just boost: RPM: 1200 - 7200 MAP: 85 - 255 CLT: 140 CUSTOM FILTER: [TPS] < 80 Just cruise: RPM: 1200 - 7200 MAP: 10 - 110 CLT: 140 CUSTOM FILTER: [TPS] < 5 I use the TPS filter to filter anything below 5% so it doesn't try to tune when I lift or idle. Likewise for boost, I filter anything below 80% TPS so it just focuses where it counts. |
All times are GMT -4. The time now is 07:29 PM. |
© 2024 MH Sub I, LLC dba Internet Brands