MS-PNP tach out?
#1
Junior Member
Thread Starter
iTrader: (1)
Join Date: Dec 2010
Location: Knoxville, TN
Posts: 279
Total Cats: 3
MS-PNP tach out?
I see in Tuner Studio the ability to enable a tach out signal from the mega-squirt. Did the pre-assembled MS-PNP have the hardward to generate that signal? Does the output signal need any external circuit to drive the dash tach
#3
Junior Member
Thread Starter
iTrader: (1)
Join Date: Dec 2010
Location: Knoxville, TN
Posts: 279
Total Cats: 3
Thanks Brain; now to verify that the shop that tried to install the MS2 and failed, resulting in the re-install of the MS-PNP did not cannibalize that circuit for their failed attempt to add a GM tach generator
I am assuming pin 40 is on one of the two connectors on the MS-PNP
is there an online resource with the various pin-outs
I am assuming pin 40 is on one of the two connectors on the MS-PNP
is there an online resource with the various pin-outs
#4
Junior Member
Thread Starter
iTrader: (1)
Join Date: Dec 2010
Location: Knoxville, TN
Posts: 279
Total Cats: 3
my goals
1 - get tach working again
2 - get preliminary spark table created/loaded
3 - get idle, cold start, accel/decal adjusted stable
4 - get AFR targets created/loaded
5 - adjust *.ini code to cause AEM WB and TS to agree at 14.7
6 - get VE table created/loaded
7 - tune, retune, retune
8 - modify MS-PNP to eliminate backfire at switch on
9 - start all over with MS2
1 - get tach working again
2 - get preliminary spark table created/loaded
3 - get idle, cold start, accel/decal adjusted stable
4 - get AFR targets created/loaded
5 - adjust *.ini code to cause AEM WB and TS to agree at 14.7
6 - get VE table created/loaded
7 - tune, retune, retune
8 - modify MS-PNP to eliminate backfire at switch on
9 - start all over with MS2
Thread
Thread Starter
Forum
Replies
Last Post
JacksonRacingEngines
Engine Performance
10
09-10-2015 09:52 AM