Having some issues with tuning 02 sensor off
Ok guys I just everything set up mspnp2 with aem 30-4100 wideband, everything is hooked up right but the 02 sensor is reading a unit higher than the wideband is. I have my propertiers for the afr table 0v=10afr 4.95v=19.9afr. it idles at 250rpms, struggles when leaving a stoplight. Right now I cant get it to start, I have the battery charging but I don't know what to do.
Thanks in advance guys |
Have you input your values to megasquirt with the curve differences or whatever that thing that you have to do with all AEM widebands?
Is your install done properly? |
I calibrated in the input voltages and the install should be done right since its plug and play lol.
|
I was unaware that there were PNP wideband setups available for Miatas.
My mistake. Carry on. |
I have learned that Plug And Play is like the word "Indestructible", there is always room to F something up. where did you choose to ground the WB.?
|
well I got it started with the change of the idle controller I had it on/off instead of pwm 2 wire. It idles really high though, then after it warms up and I restart it the idle goes really low but I can't figure out how to control it
|
All times are GMT -4. The time now is 06:12 AM. |
© 2024 MH Sub I, LLC dba Internet Brands