Easytherm values for 99 parallel
11-05-2008, 06:57 PM
#1
Slowest Progress Ever
Thread Starter
iTrader: (26)
Join Date: Oct 2007
Location: The coal ridden hills of Pennsylvania
Posts: 6,022
Total Cats: 304
Easytherm values for 99 parallel
So I searched all around and it seems that everybody is using all kinds of numbers for all different setups. I am running an MS1 3.0 in parallel on my '99 with a '97 CAS retrofit. I am using all the other stock sensors that came on my '99. What values should I have set in Easy therm? I am running a LC-1 wideband, where do I configure that to work with my MS?
Reply
0
0
11-06-2008, 08:29 AM
#2
Boost Pope
iTrader: (8)
Join Date: Sep 2005
Location: Chicago. (The less-murder part.)
Posts: 33,019
Total Cats: 6,587
For EasyTherm values, see post 7 here: https://www.miataturbo.net/forum/t13676/
For LC1 config, go into MegaTune Configurator (which can be launched from the start menu or from within Megatune) and set it up for the LC-1 default, as follows:
For LC1 config, go into MegaTune Configurator (which can be launched from the start menu or from within Megatune) and set it up for the LC-1 default, as follows:
Reply
0
0
01-20-2009, 06:17 PM
#3
Slowest Progress Ever
Thread Starter
iTrader: (26)
Join Date: Oct 2007
Location: The coal ridden hills of Pennsylvania
Posts: 6,022
Total Cats: 304
So I am using Easytherm 5.0. Tomorrow morning I am going to reburn these values.
CLT Values: RX7 Defaults
Celcius
0 6000
40 1100
80 320
IAT Values: GM
Farenheit
WHAT DO I USE HERE?
Who else is running MS-1 parallel on their 99 and what settings are you using?
CLT Values: RX7 Defaults
Celcius
0 6000
40 1100
80 320
IAT Values: GM
Farenheit
WHAT DO I USE HERE?
Who else is running MS-1 parallel on their 99 and what settings are you using?
Reply
0
0
Thread
Thread Starter
Forum
Replies
Last Post
Zaphod
MEGAsquirt
47
10-26-2018 11:00 PM
JesseTheNoob
DIY Turbo Discussion
15
09-30-2015 02:44 PM
Motorsport-Electronics
ECUs and Tuning
0
09-05-2015 08:02 AM
