Help im terrible with electronics
ok i just put in my mspnp, set the timing and all that. then i went and changed the overboost protection, but im still getting a hard cut. i dont know what i did or what to do. help!
|
Post an MSQ and a log showing a hard cut event, preferably several events.
|
what did you set the over boost protection to and how close did you get to it?
|
i set the over boost to 175 and reached maybe 155(whatever 7 psi is).
i dont have internet access on my laptop, and the battery for some reason wont hold a charge so i cant log, untill i get my new battery. **EDIT** i never got to 7 psi, the highest i can get it is 2 psi. |
NE one have any suggestions?
|
2 psi? That can't be right, unless you have a boost leak. You might be blowing out spark, which means you need to gap your plugs down most likely though that is doubtful at only 2 psi.
|
Originally Posted by roadstereunos28
(Post 274629)
NE one have any suggestions?
|
Get a voltage inverter.
It plugs into the cigar lighter socket & you plug your laptop 120 volt cord into that. Then you can log for hours if you want & you'll be charging your battery at the same time. |
+1 get an inverter. Probably cheaper than a new battery for your laptop.
|
Originally Posted by ZX-Tex
(Post 276055)
+1 get an inverter. Probably cheaper than a new battery for your laptop.
Finally just got a battery, and had the inverter. |
All times are GMT -4. The time now is 07:09 PM. |
© 2024 MH Sub I, LLC dba Internet Brands