i fucking screwed up my MS..
Q14 and 15, two of those tiney ass dioed things. Well when I was soldering i bridged the connctions, and now I cannotget them to become un bridged. I used a de soldering gun, scrapeing the bord with a fine tip, everything. what should I do? The MS doesent light up at all when plugged into the stim..
|
maybe you fried those diodes?
|
do you not have some copper desoldering wire? run to radio shack and ghrab a roll $3-4.
lay it on the legs of the transitors, press your tip onto of it and heat that shit up, you'll mop all the solder right up like water with a sponge. if you're never going to use low ohm injectors, you can skip building the pwm flyback circuit and jump R37 and R38. hell, bridge the connections temporarily and see if that solves the communication issue. |
You should have gotten a solder sucker. Its the single most important tool other then the iron when soldering.
|
it is Q14 and Q15. The problem is I have them out, but the little holes are still bridged even when there is no solder, I think I messed up the bord in that area. Im checking if they are bridged with an ohm meter, when they are bridged it reads 0 ohms.
Can I leave out Q14 and 15? I only plan to use high imp. injectors. What if the 3 little pads are still bridged? |
Dont be lazy, get a solder sucker and clean em out and do it right once.
|
Originally Posted by Saml01
(Post 193132)
Dont be lazy, get a solder sucker and clean em out and do it right once.
Ok, I bridged r37 and r38, when I plug he stim in the PMP light goes on for 2 sec then goes off. What does this mean? |
AHA! success! I got megatune to recoginize it when the ini is set at MS1. But I cannot get Msnse to write to MS, what exactly do I need to bridge> The 2 holes in the little box that says boot?
|
Yes.
|
Yes jump the boot loader. Follow the instructions for heck sake.
|
|
i was getting that message but resolved it.... did u jump the gun and set ur megatune to msns_extra before you downloaded the firmware? .... if u havent downloaded the firmware yet test it under normal MS1 .... just go to the configurator in megatune and set it to MS1
|
I already downloaded the firmware to MS. This started happening when I downloaded the firmware.
|
communication error when you flashed it. try to download it again.
|
This doesent look right.. what the fudge.?
MegaSquirt Download 2.00 Reading C:/EFI/msns-extra_mod.s19: Detected MS-I (HC908) code. Entry point: 0x0000 Code range : 0x8138-0xfffe File read successfully. Opened comm port 3 at 9600. Wake up attempted: Wakeup successful. Erasing: Erased. Writing: Write complete, 1759 records, 27788 bytes. Verifying: Signature: ޣ]@@`by@ZZJZZZZJZ Verify complete. Elapsed time: 84.24 seconds |
anyone have any idea why ited do that?
|
noone before I go to bed?
|
???? ask jerry or matt. someone else was having a similar problem.
|
jerry or matt? Its weird, everything works right except when I d/l the firmware onto the MS it changes the signature into a bunch of symbols, then that messes up megatune
|
I got it to work! I used an older vertion of MS installer! woo!
|
All times are GMT -4. The time now is 11:43 PM. |
© 2024 MH Sub I, LLC dba Internet Brands