Idle valve while cranking
Hello! Still been trying to get my cranking and idle settings tuned in how I like them. I was wondering what the idle valve duty % should be at while cranking? I have mine set at about 40% which I believe would give me an idle of about 1200 if I were to input that into the idle test mode.
Was wondering what other people had their valve set at and about what RPM that would have them idle at since fully closed and open % vary from car to car. |
Have you done the full idle output test? What are your min and max values?
|
Originally Posted by ridethecliche
(Post 1408757)
Have you done the full idle output test? What are your min and max values?
|
I suggest you set the cranking values close to the running values, as a first approach. Then adjust so that you get proper, initial flare to about 2000 RPM allowing for a settle down and engagement or Closed Loop Idle.
I use a 4 second Crank to Run taper on mine to allow the transition to be graceful. In the end, I now have the cold cranking values about where they started (near running values) but the values at hot cranking have been bumped up to maintain a good flare. Else, car will struggle to get into CLI. |
Originally Posted by DNMakinson
(Post 1408771)
I suggest you set the cranking values close to the running values, as a first approach. Then adjust so that you get proper, initial flare to about 2000 RPM allowing for a settle down and engagement or Closed Loop Idle.
I use a 4 second Crank to Run taper on mine to allow the transition to be graceful. In the end, I now have the cold cranking values about where they started (near running values) but the values at hot cranking have been bumped up to maintain a good flare. Else, car will struggle to get into CLI. |
Yeah, thanks DMak! That's really helpful. Going to look some things over on my end too given recent issues with hot starts.
|
Originally Posted by ridethecliche
(Post 1408783)
Yeah, thanks DMak! That's really helpful. Going to look some things over on my end too given recent issues with hot starts.
|
Originally Posted by dawson128
(Post 1408786)
Ive got some pretty bad hot start issues, but the thing is, the stock ECU had them too... Definitely worse with the megasquirt however. I flattened out my MAT correction and added a ton of ASE with a really long taper at higher temps.
|
All times are GMT -4. The time now is 12:59 PM. |
© 2024 MH Sub I, LLC dba Internet Brands