Injector cut at 7psi.. please help
2 Attachment(s)
Hoping someone can help me out here, just got my miata up and running with a pieced together turbo kit and I'm running into an issue.
the car starts to pull great and then it hits 7 psi and jerks for a second and falls in rpms. At first I thought it was spark blow out so i gapped my plugs smaller and tried again and no luck. I looked over my logs and my injectors go to 0% duty at 7psi and stay at zero until it falls to about 5 psi. Hoping someone maybe has some input on what could be cause my injectors to die out only at that specific load. I'll link the log as well thank you!! Injectors are 420cc rx8 t25/28 hybrid from begi running on ms2pnp |
Perhaps you have boost cut set at ~7psi?
|
Originally Posted by Full_Tilt_Boogie
(Post 1205546)
Perhaps you have boost cut set at ~7psi?
I'm thinking it may be a boost leak just not sure if that would cause my fuel to go like that. |
Overboost protection.
Check it out. |
Injector cut at 7psi
Originally Posted by Bmxicanjohn
(Post 1205561)
you can only set boost cut if your using megasquirt to control boost right? i"m running a mbc should have mentioned that. and my waste gate is set at 10psi.
I'm thinking it may be a boost leak just not sure if that would cause my fuel to go like that. |
Originally Posted by 18psi
(Post 1205586)
lol found your problem
|
Originally Posted by Erat
(Post 1205578)
Overboost protection.
Check it out. |
Overboost protection, commonly called "boost cut" on the streetz.
|
Originally Posted by Full_Tilt_Boogie
(Post 1205597)
Overboost protection, commonly called "boost cut" on the streetz.
|
Originally Posted by Erat
(Post 1205602)
Only for those to scurrred to run ALLOFIT.
|
All times are GMT -4. The time now is 07:05 PM. |
© 2024 MH Sub I, LLC dba Internet Brands